Step 1. PREP!
Prepares the hair to receive the color.
Use Color Primer
Specifically designed as the first step in the Evolution of the Color3 Fast service.
Prepares hair for the color service, helping to achieve a uniform and homogeneous color, without streaks or color overload.
Spray onto lengths and ends of dry hair before applying color.
Do not rinse.
Step 2. COLOR!
Apply and start the stopwatch.
• Begin the application by dividing the hair into 4 sections as usual.
• Spread the mixture with the appropriate bottle to speed up the application (average application time 5/8 minutes; respect this time even if you prefer to apply with the brush).
• Always start at the nape of the neck. Make sure all natural hair is covered with the coloring mixture. Apply only to natural hair.
• At the end of the application, start the calculation of the exposure time,10 minutes for normal hair.Always check the color result on the front of the head.
• To even out the colour: in the last few minutes of application, gently remove the colour from the scalp and distribute it over the lengths and ends previously wet with warm water.
• Massage constantly until the desired result is achieved; then rinse.
TONE HEIGHTS and OXYGEN VOLUMES %
2-4 use: 20 VOL (6%) - 30 VOL (9%)
5-6 use: 30 VOL (9%) - 40 VOL (12%)
7-8-9 use: 40 VOL (12%).
Step 3. BLOCK!
When the stopwatch sounds, rinse and lock.
Use Color Block Shampoo
It stabilizes the action of the coloring pigments, interrupting their oxidation process and ensuring color fidelity over time.
To be used exclusively at the end of an Evolution of the Color3 Fast color service.
Distribute on damp hair, emulsify until obtaining a homogeneous foam throughout the hair, leave on for 1 to 2 minutes, finally rinse thoroughly before proceeding with the application of the conditioner/cream most suitable for the client's needs.
Do not use in other situations, because due to its hydrogen peroxide content it can alter the hair color if left on for more than 2 minutes.